LÖWEN HB8 - Fixing the Device to the Wall; Hollow-Wall Mounting

Technical Manual LÖWEN Dart HB8
01/2019 14
3.2. Fixing the Device to the Wall
WARNING: The device can tip. The danger of possible bodily injury or death exists. The device
must be fixed to the floor and/ or to the wall to secure it against falling over. The
necessary fastening hardware is included with the device.
Enclosed fastening hardware:
D: Eyebolt with chain
E: Screw
F: Nut
G: Washer
H: Spring toggle bolt
J: Eyebolt
K: Wall plug
L: Wood eyebolt
M: Screw
N: Washer
P: Floor plug
R: Fender washer
Required tools: Tape measure or scale, size 1 screwdriver, size 1 Phillips head screwdriver,
combination pliers, 6 mm and 12.5 mm wood-metal drills, 6 mm and 12.5 mm
masonry drill
Fixing the Eyebolt and Chain on the Device Upper Part
1. Screw the eyebolt with chain 'D' midway into the back wall of the device's upper part.
2. Place the device into play position and mark a point on the wall directly in line with the eyebolt and
chain on the device's back side.
Hollow-Wall Mounting
3. Drill a 12.5 mm diameter hole at the spot marked.
4. Turn screw 'H' out of the spring toggle bolt.