Piccolo 23 from 82
www.lt-light.com
In menu 30, a new option has been added: Chan->CH.MD. This
option allows limiting the available channel banks. For a 48 channel
Piccolo, if you are using only 24 channels, you can configure [CH.MD] to
toggle only between the first 2 banks.
Channels not in the banks can be edited using the function keys. At any
time this option can be changed without affecting the show or the stored
scenes.
14. STORING GROUPS
A group is a combination of channels (with or without level) that can be used for editing (as a quick
selection) or as scenes loaded to Submasters or inside an Effect. No groups can be used with the
Crossfader.
Current scene and selections are stored in Groups
Example, store a group with the channels from 1 to 5:
Select these channels (using one of these options):
o With level editing: [CHANNEL] [1] [THRU] [5] Encoder
o Moving the faders: C1 to C5 over 0%
o Selecting the channels without level (will be stored at FF):[CHANNEL][1][THRU][5]
And, store the group as:
o Next group to the last group # stored: [GRP] [REC]
o Group number #: [GRP] [#] [REC]
Only in THEATRE & MANUAL modes
As next group loading to a Submaster: [LOAD] [S#]
Groups stored directly using [LOAD], start from group 500. Avoiding that groups stored
using [LOAD] and groups stored using [GRP][REC] can be confused. This number (i.e.
500) can be changed in Setup. To eliminate the second index setting it can be set to 1. This
option is in Menu 30, option Load Grp Num.
If desired, jsut now, you can press [OPTIONS] and edit times and text of the just stored group.
Exit of options function pressing [EXIT], [OPTIONS], or [LOAD] [S#]
Also you can access to options for a particular group, pressing:
[GRP] [#] [OPTIONS] (Editing times and text) [OPTIONS]
To Next Page
Loading...
