Piccolo 24 from 82
www.lt-light.com
It is possible to associate a text to each group, or different times o fade or/and delay and different
timings entering in the groups table: [GRP] [GRP]. This text is used to identify the groups and can
be seen when the group is loaded to a Submaster. The times are used in the automatic fades done
with [S#]
Inside this screen, [OPTIONS] toggles between the groups options & groups list.
Each new group is stored with the default time for cues & groups. These default times are the same
times for cues & groups, and can be changed inside menu 30, inside cue list or inside groups list.
15. STORING CUES
A cue is a combination of channels with levels that can be used for editing and for the playback (as
scenes) loaded in Submasters, Effects and the Crossfader.
Scene is stored in the Cues
Example, store a cue with channels from 1 to 5 at 100%:
Select these channels (using one of these options):
o With level editing: [CHANNEL] [1] [THRU] [5] Encoder
o Moving the faders: C1 to C5 at 100%
And, store the cue as:
o Next cue to the last # stored: [REC]
o With cue number #: [CUE][#][REC]
If desired, jsut now, you can press [OPTIONS] and edit times and text of the just stored cue.
Exit of options function pressing [EXIT], [OPTIONS], [LOAD] [S#] or [ASSIGN]
o Also you can access to options for a any other cue, pressing:
[CUE] [#] [OPTIONS] (Editing times and text) [OPTIONS]
It is possible to associate a text to each cue, and to edit times, jumps and commands. Entering in to
the cues table: [CUE] [CUE]. Inside this table:
[CUE] [CUE] This command, searches the cue in X2 (next cue in the crossfader), and the
second time searches the first stored cue in the cue list
[OPTIONS] Toggles between the general options & cues options.
[EXIT] Closes the table/list.
General options:
Listed are: the default values for the fade-times, auto-time, time parameters for the crossfader and
the go-back function (are the same values that are in menu 30).
To Next Page
Loading...
