DRIVER’S COMPARTMENT -
INSTRUMENTS AND CONTROLS
16
High beam indicator
Right hand and hazard
indicator
Oil pressure indicator
EIV 0009
Direction indicators.
Either the left hand or right
hand warning lamp will flash
green in time with the indicator lamps in the
direction determined by the direction indicator
switch. Both lights will flash together when the
hazard warning switch is on.
CAUTION: If the warning light flashes
incorrectly this indicates that a bulb in
the indicator circuit (front, side
repeater or rear) may have failed and should
be replaced at the earliest opportunity.
High beam indicator
This blue light comes on when the
headlamp high beam is on, and goes
out when low beam is selected.
Engine electronics function
If this illuminates, an engine
management system malfunction is
indicated. This may be the failure of an engine
sensor that will not stop the engine but will
result in a loss of power, increased emissions
and fuel consumption. Have the vehicle
checked out by an LTI Dealer immediately.
Engine management system
If this illuminates, engine management
control module malfunction is
indicated. In addition to a loss of power,
increased emissions and fuel consumption, the
engine may begin to lose power and may
eventually fail to restart. You are advised to
stop driving the vehicle and have it checked out
by an LTI Dealer immediately.
Brake light bulb failure indicator
This will illuminate if either right or left
hand brake light bulbs has failed. You
should attend to this immediately. Note: this
does not indicate any failure in the high-level
rear brake light mounted in the heated rear
window or of any other bulb on the vehicle.
Note: This feature will always illuminate as a
self-test each time the ignition is turned on and
will cancel the first time the brakes are applied.
Water in fuel indicator
This will illuminate if a significant
presence of water is detected in the
bottom of the fuel filter cartridge. This should be
attended to immediately by the draining of the
fuel filter (see page x). if this does not rectify the
condition you should have it checked out by an
LTI Dealer immediately.
Seat belt indicator
Not used in this variant
Security LED
This indicates the status of the engine
security system. It will flash regularly
when the ignition key is removed to indicate that
the engine immobilizer is active. See security
system diagnosis on page 8 for further detail.
Lights continuously when the ignition key is
turned to position II. Extinguishes when the key
has been recognised. Flashes rapidly if fault is
present.
Left hand direction
indicator
Engine electronics function
Engine management
system
Brake light bulb failure
indicator
Water in fuel indicator
Seat belt indicator
Security LED
Windscreen washer
fluid level
To Next Page
Loading...