DRIVER’S COMPARTMENT -
GENERAL EQUIPMENT
28
Checking seat belt operation
The seat belt retractors are designed to lock belt
movement by two separate methods - when the
seat belt is pulled quickly from its retractor, and
when the vehicle slows down rapidly.
The seat belt operation may be tested as
follows:
1. Grasp the shoulder belt and pull it forward
quickly. The retractor should lock up
immediately and prevent any further belt
movement.
2. The following test must be carried out
under safe road conditions, i.e. a dry road
with no following or oncoming vehicles.
With the belts in use, drive the vehicle at a
steady 5 mph. (8 kmh) and brake sharply. The
automatic locking devise should operate and
lock the belt. It is essential that the driver and
passenger are sitting in a normal relaxed
position when making this test - the retarding
effect of braking must not be anticipated. If the
retractor fails to lock during this check you
should consult your authorized Dealer.
DRIVER'S SEAT ARMREST (where fitted)
The driver’s seat armrest is an option on some
models. To adjust the height to suit the
individual, turn the adjuster drum under the front
of the armrest until the desired position is
achieved.
The armrest can be moved to the upright
position without disturbing the height adjustment
Interior Mirror
The mirror head may be adjusted as required.
To reduce dazzle, press the lever (A) towards
the windscreen; return the mirror to its original
setting when required.
Clock
The 24 hour display clock is situated in the roof
console. Adjust the hour displayed by pressing
the button (h) until the required display is
achieved. Similarly adjust the minutes displayed
by pressing the button (min).
WARE 28
WARE 27
To Next Page
Loading...