EasyManua.ls Logo

LTI TX4 - Clutch and Brake Hydraulic System Maintenance

LTI TX4
95 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MAINTENANCE REQUIREMENTS
57
FUEL TANK EMPTY
Your vehicle is equipped with a system that
helps prevent the complete emptying of the fuel
tank.
If the fuel gauge indicates low fuel or the
low fuel warning light illuminates, please
refuel immediately.
Some time after the low fuel level warning light
has illuminated, when the fuel reaches a very
low level, the engine will start to run unevenly as
an additional warning. Proceed to the next filling
station and refuel with at least 8 litres of fuel.
Failure to refuel will result in the engine
running dry. This will lead to a difficult
restarting procedure which requires
roadside assistance. Also, serious engine
damage may occur.
LUBRICATION
Always use high quality oils and greases of the
correct specification shown in the table below.
The use of incorrect or poor quality lubricants
can lead to high oil and fuel consumption, and
ultimately may cause damage to components.
Engine oils of the correct specification contain
additives which disperse the corrosive acids
formed in combustion and prevent the formation
of sludge which can block oil ways. Additional
additives should not be used.
LUBRICANT SPECIFICATIONS
Component Minimum Performance level
& Specification
Engine: Specification to meet or
exceed any of the
following: API: CG-4, CH-4,
CI-4 or ACEA: B3, B4, B5
to Grade/Viscosity 10W 40
Fully Synthetic oils, to
grade 5W40 and 0W40 may
be used to improve the
overall engine behaviour
(cold start-ability, fuel
economy, oil change
intervals)
Automatic Daimler Chrysler (DCX)
Transmission specification MS 9602
Manual Gearbox (Chrysler ATF +4)
and Power
Steering
Rear Axle Shell Spirax Super 90TS

Table of Contents