LTI TX4 - Power Window Controls

DRIVER’S COMPARTMENT - INSTRUMENTS AND CONTROLS
23
Driver's compartment door windows
The rocker switch (A) in the driver's door arm
rest operates the driver's door window, switch
(B) is for the window in the left hand door. These
switches operate with the ignition key in position
I and ll. Push and hold the switch in the 'up' or
'down' position until the required position is
achieved. A short push will activate the one
touch down facility on either front window,
pushing the switch again in either direction will
cancel the operation.
There is a similar switch for the window in the
left hand front door. This is available as an
optional extra.
Passenger compartment windows - driver's
control switches
Operating the rocker switches (C) located in the
centre console to the rear of the gear lever, will
allow the driver to raise or lower the rear door
windows as required. These switches operate
with the ignition key in position I and II.
The switches must be held 'up' or 'down'' until
the required window position is reached.The
centre switch will disable power to the rear
windows only.
Centre switch (D) will disable power to the
switches in the rear compartment only. As a
“Driver Command Feature” the windows will
always remain under the control of the switches
in the drivers compartment.
WARNING
Electrically operated windows may be
dangerous to the operator or others,
particularly children, if used improperly, with
the risk of entrapment. It is the responsibility
of the driver or passengers using the electric
windows to exercise caution in use, and to
avoid putting any part of the body or other
object through the open window aperture
that may be injured or trapped.
If any type of remote closure system is fitted
to the vehicle, whether as part of a security
system or as an accessory, it is the
responsibility of the operator to ensure a
clear view of all the windows when operating
the system, to ensure that there is no person
or object nearby that may be injured or
trapped.
Driver’s and passenger compartment
windows
Should a window stop moving during operation,
release and retry the switch. If there is a fault or
overload detected the window will move 2cm in
the required direction then stop. Continue to
retry the switch until the window is closed.
A
B
EURO 16
EIV 0012
C
D