EasyManua.ls Logo

LTI TX4 - Tyre Care and Wiper Blade Replacement

LTI TX4
95 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MAINTENANCE REQUIREMENTS
60
BATTERY
A maintenance free battery is fitted. For all
matters concerning battery operation consult
your authorised LTI Vehicles Dealer.
Your vehicle is equipped with a
lead/calcium battery. When replacing
the battery use only a lead/calcium
battery of the type listed by LTI Parts. No
other battery is to be used. Contact your LTI
Dealer or local authority for battery and
disposal replacement.
Cleaning battery terminals.
From time to time the battery terminals should
be cleaned. With the ignition switch off,
unclamp and pull off the terminals (remove the
earth (black) terminal first. Clean the terminals,
apply petroleum grease, and replace and tighten
the terminal clamps (earth terminal last). Reset
the vehicle time clock.
CAUTION: Never disconnect the
battery from the vehicle if the engine
is running as this could cause severe
damage to the electrical system.
Note: on connection, the vehicle security system
alarm (where fitted) will operate and should be
disarmed using the remote key or key pad.
COOLING SYSTEM
WARNING: To avoid injury from
escaping steam and scalding water,
the radiator cap and the pressure
relief cap of the expansion tank must not be
removed while the system is hot.
EIV 0029
EIV 0029
EIV 0039
EIV 0039
Topping up
The coolant level should be checked when the
engine is cold. The coolant level should then be
at the mark half way down the side of the
expansion tank (A). If necessary slowly remove
the pressure relief cap (B) from the expansion
tank and add the specified coolant to bring the
fluid level up to the mark.
Clean water may be used temporarily if coolant
containing the specified antifreeze corrosion
inhibitor (see below) is not available. Do not
overfill the expansion tank as this will result in
coolant loss through the overflow pipe as the
coolant expands with increasing engine
temperature.
CAUTION: The cap fitted to the
radiator is not a pressure cap. It must
never be replaced with a pressure cap
of any type.

Table of Contents