PASSENGER COMPARTMENT -
SPECIAL FACILITIES
43
Additional Step
An additional step is provided and stored in the
boot. When it is necessary to help the
passenger enter the vehicle, position the vehicle
slightly away from the kerb so that the step can
be slid into the brackets (A) located on the
vehicle chassis below the left hand rear door
aperture. Position the door closing stop bracket
(B) to the right and in its upright position, before
pushing the step fully home into the brackets.
When the passenger is seated correctly, pull out
the step and store it in the luggage
compartment adjacent to the driver, until it is
required again at the end of the journey.
NOTE: Periodically clean and grease the interior
faces of the brackets (A) to ensure the step sides
readily into position.
Swivel seat and additional step
The fold-down occasional seat fitted to the left
hand side of the passenger compartment
swivels round into the door aperture to provide
improved access for passengers with limited
movement . The seat and its passenger can
then be swivelled into the vehicle and the seat
locked into position.The additional step may
also be used in conjunction with the swivel seat
as required.
Release the seat by opening both left hand
doors before pulling the seat catch knob (C)
situated to the front of the centre division. Pull
the seat down and round into the door aperture
until the cushion locks in the down position and
the lock strut stops further rotation. Return the
seat a few degrees until a lock stop is felt. The
seat is now safe for operation.
Assist the passenger onto the seat. To unlock,
swivel both seat and passenger outwards until
the strut stop is reached again. The seat and
passenger can then be swivelled into the vehicle
until the latch engages.
At the end of the journey, release the seat catch
and swivel the seat and its passenger into the
door aperture until the lock strut stops further
rotation. Return the seat a few degrees until a
lock stop is felt. The seat is now safe for
operation. Assist the passenger to leave the
vehicle and return the seat to its normal
position, ensuring the seat retaining latch is
engaged.
NOTE: The cushion will remain in the down
position until the seat is latched back to the
division in the travelling position.
EURO 27
WARE 261D
A
B
EURO 28
C
To Next Page
Loading...