REPLACEMENT OF BULBS AND FUSES
68
Number plate light - bulb replacement
Note the position of the light lens (A). Unscrew
the two screws (B) securing the lens. Pull the
lens out from the number plate plinth to gain
access to the festoon bulb (C) and pull out the
bulb from its connector clips. Replace the bulb
and then the lens, ensuring it is in its original
position before securing the lens back into in
the number plate plinth.
Hire sign light - bulb replacement
Pull down the back edge of the driver’s interior
light (E) from the roof lining to gain access to
the taxi sign bulbs. The required bulb holder (F)
should be turned anti-clockwise to release it
from the hire sign body. Each bulb is a bayonet
fitting in its bulb holder.
Replace the defective bulb and install the bulb
holder in the hire sign body. Position the lugs at
the front of the interior light above the edge of
the centre console trim before clipping the light
unit into place.
To Next Page
Loading...