LTI TX4 - Parts Warranty and Vehicle Identification

VEHICLE AND PARTS WARRANTIES
iv
VEHICLE WARRANTY
If your vehicle requires attention under the
terms of the warranty:
● Take your vehicle to the authorized Dealer
from whom you purchased the vehicle. If this
is impractical, you may contact any other
authorized Dealer.
● Provide the Dealer with full information about
the nature of any difficulty as quickly as
possible.
● Always provide the Dealer with this Owner's
handbook to provide the vehicle details
required, and the full vehicle service history
as described on page iii to verify that the
correct routine maintenance services
specified by the manufacturer have been
carried out.
PARTS WARRANTY
After the vehicle warranty has expired, any
genuine part purchased by the operator either
when fitted as part of a maintenance operation
or repair, or as an over the counter sale, is
warranted by the manufacturer as indicated on
page ii.
In the case of a manufacturing or material
defect occurring to a genuine part:
● Return the part (or the vehicle to which the
part is fitted) to the Dealer who sold the part.
● Explain the nature of the defect; show the
Dealer the invoice you received when the part
was sold, and also any Major Unit Certificate
which may have been issued at the time of
sale.
Where the defect cannot be readily determined,
your Dealer may charge for the replacement
part while it is returned to the manufacturer for
examination: you will be re-imbursed when the
examination confirms that the part failed due to
a manufacturing or material defect.
Note: It is in your best interest to use the
manufacturer's genuine parts which are
warranted for use on your vehicle.
VEHICLE AND PARTS IDENTIFICATION
The Vehicle Identification Number (VIN) shown
on the inside cover of this booklet, is stamped
on a plate attached to the sill of the Driver's
door, and also on the body beneath the floor
covering to the rear of the right hand front seat.
The engine number is stamped on the left hand
side of the engine block immediately above the
engine mounting bracket. It is also repeated on
a paper label at the top of the timing belt cover.
A number of components are identified with bar
coded labels, or identified using a micro dot
process, to indicate they were fitted to the
vehicle at the time of manufacture.
Always fit replacements parts which are
appropriate to the identification numbers shown
on your vehicle.
Note: removal of the bar coded labels or
identification marks will invalidate any warranty
which may be applicable to the component
concerned.