EasyManua.ls Logo

LTI TX4 - Additional Step and Swivel Seat Operation

LTI TX4
95 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PASSENGER COMPARTMENT -
SEATS & SEAT BELTS
41
OCCASIONAL SEATS
Rear facing occasional seats (A) are fitted to
each side of the centre division. The cushion of
these seats is normally held up by springs; the
cushions may be pulled down for use when the
seats are required.
Seat belts - occasional seats
Inertia reel seat belts are provided for each
occasional seat.
Note: The belt fitted to the left hand swivel seat
has an additional fixed tongue and buckle (B)
which is only used when the belt is being
positioned for use by a wheelchair passenger
(see page 45).
WARNING: This additional tongue
should only be removed from its
buckle when a wheelchair passenger
is being positioned in the vehicle. When the
ignition is switched on a continuous audible
warning will sound whenever the fixed
tongue and buckle are separated. The
vehicle should never be driven in this
condition.
The seat belt should be slowly drawn from its
retraction guide (C) on the body pillar and
passed over the shoulder before inserting the
sliding tongue on the belt into its buckle (D) on
the centre division, until a “click” confirms full
engagement.
Ensure the belt is not twisted and position the
lap belt portion low over the hips (never across
the soft parts of the abdomen). Pull the shoulder
portion of the belt back towards the retraction
guide on the body pillar to remove any slack.
Depress the red button on the buckle to release
the belt; the belt will retract automatically.
Note: The seat belts should be checked and
cleaned periodically as described on page 27.
WARE 54A
EURO 26
A
C
C
D
B

Table of Contents