DRIVER’S COMPARTMENT -
INSTRUMENTS AND CONTROLS
19
LIGHTS, BEAM SELECTOR AND TURN
INDICATOR SWITCH
Lighting
Turn the switch anti-clockwise as follows:
Off
Front and rear side lights, rear
number plate light and instrument
lighting.
Headlights on (when ignition switch
is on).
Light warning buzzer
A warning buzzer will sound if the light switch is
turned on when the driver's side door is open
with the ignition off.
To select high beam, push the lever away from
you (A). The warning light in the instrument
cluster will glow 'blue' in the high beam position.
Pull the lever towards you (B) for low beam.
Headlight flasher
When the ignition is switched on, pulling the
lever toward you (C) against spring pressure will
operate the headlight flasher. This switch also
operates when the lighting switch is off.
Indicator switch
Move the lever fully up or down to signal right
(D) or left (E). When the turn has been
completed, the indicators will cancel
automatically. The appropriate warning light in
the instrument cluster will flash in time with the
indicators.
CAUTION: If the warning light flashes
incorrectly this indicates that a bulb in
the indicator circuit (front, side
repeater or rear) may have failed and should
be replaced at the earliest opportunity.
Lane change signal
To indicate a lane change, move the indicator
switch up or down to the point where the
indicators begin to flash. The lever will return to
its off position when released.
WARE 10
D
E
A
B
C
•
•
•
•
OFF
To Next Page
Loading...