REPLACEMENT OF BULBS AND FUSES
69
Hire sign repeater bulbs
The festoon type bulbs may be replaced by
removing the screw (A) securing the light box
lens unit (B) and pulling out the defective bulb
(C) from its clips.
Interior lights
Carefully pull the edge of the lens surround
down from the head lining to give access to the
rear of the lamp. Lift the circuit board away from
the retaining clips on the lens. Pull the festoon
bulb from its clips.
After fitting the new bulb, push the circuit board
back into the lens until retained by the clips.
Push the lamp back into position.
To Next Page
Loading...