Lucent Technologies DDM-2000 OC-12 User Manual

363-206-295 DLP-542
4of3Page1997December1,Issue
Use8. switch-sync:s=circuitpack,pri=manual switchtocommand
protectiontotiming TGS/TG3 in TIMING slot 2 active.alreadynotif,
Response: ACTIVE onlightsLED TGS/TG3 inpackcircuit TIMING
slot 2.
9.
NOTE:
timingDS1forcablesmultbayandusedismodetimingexternalIf
aremovingbay,ainshelvesconnectreferences TGS/TG3 packcircuit
timingDS1incomingassociatedtheoflossmomentaryacauses
ainresultmayThisreference. LOSref.sync.DS1inc. alarm
baysamethetoconnectedarethatshelfthisaboveshelvesallon
affectnotdoesreferencetimingoflossmomentaryThiscabling.mult
transmission.
oldRemove TGS/TG3 frompackcircuit TIMING slot 1.
thedepressMomentarily10. UPD/INIT theonpushbutton SYSCTL.
newInsert11. TGSBBF2B / TG3BBF4 intopackcircuit TIMING slot 1.
Response: FAULT onlightsLED TGS/TG3 slotinpackcircuit 1.
12.
NOTE:
(criticalThe CR theafterseconds15toupforlightmayLEDalarm)
UPD/INIT theondepressedisbutton SYSCTL indicatenotdoesThis.
interruption.servicea
thedepressMomentarily UPD/INIT theonpushbutton SYSCTL.
Response: FAULT onlightsLED TGS/TG3 inpackcircuit TIMING
slot 2. FAULT onoffgoesLED TGS/TG3 packcircuit
in TIMING slot 1 seconds.15aboutafter ACTIVE
onoffgoesLED TGS/TG3 inpackcircuit TIMING slot
2 onlightsand TGS/TG3 inpackcircuit TIMING slot
1.

Lucent Technologies DDM-2000 OC-12 Specifications

General

Brand	Lucent Technologies
Model	DDM-2000 OC-12
Category	Multiplexer
Language	English