Lucent Technologies DDM-2000 OC-12 User Manual

SET-STATE-T3 2of1Page SET-STATE-T3
NAME
StatePortT3Setset-state-t3:
FORMATINPUT
set-state-t3: Address :ps= PrimaryState ;
DESCRIPTION
usediscommandThisports.DS3moreoroneofstatethesetscommandThis
port.specifiedafromfailuressignaltoduealarmtheoffandonturnto
are:parametersinputThe
Address port(s).DS3theidentifiesAddress
Addresses:PortDS3Valid {a,b,c,d}-{1-3,all},all
ps followingtheofonehavemaywhichstateporttheisPrimaryState
values:
auto theatsignalgoodformonitoredbetostateSet
port.specified
nmon not-alarmed.tostatememorySet
NOTE:
theinisportaIf nmon thetoreturnedbemustitstate, auto usingstate,
becanportthatwithassociatedpackscircuitanybeforecommand,this
thebylistequipmentthefromremoved update command.
ofstateportaIf nmon displayed:bewillmessagefollowingtheentered,is
)s(troP*/ sserdda /*etatssihtnidemralaebtonlliw
OC-12DDM-2000 1997December1Issue 11-301

Lucent Technologies DDM-2000 OC-12 Specifications

General

Brand	Lucent Technologies
Model	DDM-2000 OC-12
Category	Multiplexer
Language	English