363-206-295
Administration and Provisioning
Issue 1 December 1997 8-3
■ set-lgn — Set Login
■ set-secu — Set Security
■ set-sync — Set Synchronization characteristics.
When security is enabled (default is “disable”), the following additional commands
become restricted to privileged users only:
■ apply — Locally Overwrite Executing Software
■ cpy-prog — Copy Program
■ dlt-osacmap — Delete OS application context ID map
■ ent-osacmap — Enter OS application context ID map
■ ent-tl1msgmap — Enter TL1 message map for OS
■ ent-ulsdcc-l3 — Enter Upper Layer Section DCC - Layer 3
■ ent-ulsdcc-l4 — Enter Upper Layer Section DCC - Layer 4
■ dlt-ulsdcc-l4 — Delete Upper Layer Section DCC - Layer 4
■ init-pm — Initialize Performance Monitoring
■ ins-prog — Install Program
■ reset — System Reset
■ set-date — Set network element (NE) Date and time
■ set-ne — Set NE name.
■ set-x25 — Set X.25 baud rate for OS.
Reports-only users can execute the following commands: ? (help), logout,
rlgn, set-passwd (their own), toggle, and all rtrv commands except,
rtrv-lgn, and rtrv-passwd.
For details on these and other commands, see Section 11, "Commands and
Reports."
To Next Page
Loading...
Need help?
General
