363-206-295
Administration and Provisioning
8-12 Issue 1 December 1997
TARP Provisioning 8
Although TARP functions automatically, using standard default values and without
any user provisioning, DDM-2000 allows provisioning of the following TARP
parameters. All TARP parameters are provisioned by the CIT and TL1 ent-
ulsdcc-l4” command and include the following:
■ Lifetime
■ Manual Adjacency
■ Timers
■ Loop Detection Buffer (LDB) Flush Timer
■ TDC Enable/Disable
■ TDC TID-NSAP Entries
It is recommended that TARP default values always be used, with the possible
exceptions of Manual Adjacency and the TDC parameters. TARP Manual
Adjacency may be used to propagate TARP messages beyond any non-TARP
nodes in a subnetwork, if necessary. In the unlikely event the TDC contains
inaccurate information, the TDC parameters may be used to update the TDC.
Eliminated Provisioning: Because DDM-2000 OC-12 Release 7.0 does not
support Lucent Directory Services (LDS) or Remote NE Status features, the
following OI-related provisioning is no longer necessary:
■ AGNE
■ Alarm Group Number
■ DSNE
■ DSNE DLT-TADRMAP (CIT and TL1 command)
■ NE Number
■ Site Number
■ TBOS Number
Level 2 Provisioning 8
Subnetwork partitioning also involves the assignment of level 2 Intermediate
Systems (ISs). The ent-ulsdcc-l3 command is used to assign DDM-2000 to
serve as a level 2 IS. See the ent-ulsdcc-l3 command in Section 11,
"Commands and Reports," for more information on NSAP provisioning.
To Next Page
Loading...
Need help?
General
