363-206-295
Administration and Provisioning
8-42 Issue 1 December 1997
Notes
1. Default means factory default (the CIT prompts display current provisioned values).
2. To view the current values, precede these commands with •rtrv- instead of •set-.
* When security is enabled, this command is available to privileged users only (default is
“disable”).
† AUTO means the port or channel is ready to be automatically provisioned via signal detection.
‡ This command is restricted to privileged users only.
¶ Setting this parameter also affects DS1 output source and sync output mode. See set-sync
command in Section 11, Commands and Reports.
§ (X) indicates multiple parameters. See the command pages of ent-ulsdcc-l4.
To Next Page
