363-206-295
Maintenance Description
9-42 Issue 1 December 1997
Reports 9
This section provides information in reports available through the CIT. For reports
available through the X.25 link, refer to 824-102-151,
DDM-2000 Multiplexers
Operations Systems Engineering Guide
.
Database Change Transmission to OS 9
All provisioning changes are automatically reported to the OS over the TL1/X.25
interface.
Alarms and Status Report 9
The system provides a report that lists all active alarm and status conditions. The
identity of the condition (circuit pack failure, incoming OC-3 signal failure, etc.) is
included in the report along with a time stamp indicating when the condition was
detected. See the rtrv-alm command in Section 11, "Commands and Reports,"
for a complete list of the alarm and status conditions that are reported by the
system.
Provisioning Reports 9
Provisioning reports list the current state of all provisionable options in the
system. See the rtrv-attr-alm, rtrv-attr-cont, rtrv-attr-env, rtrv-
fecom, rtrv-lgn, rtrv-link, rtrv-ne, rtrv-oc3, rtrv-oc12, rtrv-
pmthres-line, rtrv-pmthres-sect, rtrv-pmthres-sts1, rtrv-
pmthres-t3, rtrv-passswd, rtrv-secu, rtrv-ec1, rtrv-sts1, rtrv-
sts3c, rtrv-crs-sts1, rtrv-sync, and rtrv-t3 commands in Section 11,
"Commands and Reports."
Maintenance History Report 9
A maintenance history report containing the past 500 alarm, status, protection
switching, and CIT (for example, provisioning, loopback request, manual
protection, etc.) events is provided. This summary contains real time and date
stamps indicating when each condition was detected and when it cleared. CIT
events contain a time stamp indicating when the command was entered. Alarm
and status entries in the retrieve history report are not subject to holdoff and clear
delay. See the rtrv-hsty command in Section 11, "Commands and Reports."
To Next Page
Loading...
Need help?
General
