Issue 1 December 1997
11-1
11
Commands and Reports
11
Overview
11
This chapter describes the command and report features of the American
Standard Code for Information Interchange (ASCII) terminal interface to a
DDM-2000 OC-12 Multiplexer. It provides detailed information about each
command, as well as system report outputs and explanations.
Reason for Issue
11
This chapter provides the details of software commands for OC-3 Release 7.0.
This release features Target ID Address Resolution Protocol (TARP) which
provides for multi-vendor interworking. With this feature, some commands
available in earlier releases are no longer applicable. Similarly, there are several
new commmands in Release 7.0 not available in earlier releases. For additional
information on TARP, please refer to the “About This Document” section.
Command Page Format
11
This chapter includes DDM-2000 commands that are presented as one- or
multiple-page entires in alphabetical order. The name of each command appears
at the top of each page.
Each entry is presented in a common format:
— The NAME part gives the name of the command and summarizes its
funtion.
— The INPUT FORMAT provides the syntax for each command. Each
command starts with a command name followed by a colon. Parameters
follow the colon. Optional parameters are enclosed in square brackets [ ].
To Next Page
Loading...
Need help?
General
