363-206-295
Commands and Reports
Issue 1 December 1997
11-9
The following comands are always restricted to privileged users only:
— init-sys (initialize system)
— rstr-passwd (restore password)
— rtrv-lgn (retrieve login)
— rtrv-passwd (retrieve password)
— set-fecom (set far-end communication)
— set-lgn (set login)
— set-secu (set security)
— set-feat (set feature)
— set-sync (set synchronization)
When security is enabled on a system, the following commands become
restricted to priviliged users only:
— cpy-prog (copy program)
— dlt-osacmap (delete OS application context ID map entry)
— ent-osacmap (enter OC application context ID map entry)
— ent-ulsdcc-l3 (enter upper layer section DCC, Layer 3)
— ent-ulsdcc-l4 (enter upper layer section DCC, Layer 4)
— ent-tl1msgmap (enter TL1 message map for Operations Systems)
— init-pm (initialize performance montoring)
— ins-prog (install program)
— reset (reset system software)
— set-date (set date)
— set-ne (set network element)
— set-x25 (set X.25 link)
When security is enabled on a system, only the following commands may be
executed by Reports-Only users:
— ? (help)
— logout (log out)
— rlgn (remote login)
— set-link (set link)
— set-passwd (set password)
— T (toggle)
— all rtrv commands except rtrv-lgn and rtrv-passwd
Refer to the set-secu command for more details on system security.
To Next Page
Loading...
Need help?
General
