Lucent Technologies DDM-2000 OC-12 User Manual

SET-SYNC 6of2Page SET-SYNC
FORMATINPUT
aforprovisionedwhencommandthisforavailableareparametersfollowingThe
upondependingvarymayParametersreference.synchronizationspecific
rings.orlinearisapplicationthewhether
TIMEDLINE-SYSTEMSRING
set-sync:[mdsw= ModeSwitching ][,src= SynchronizationSource ]
[,auto= SyncAutoreconfiguration type)packBBF2Bor(BBF2];
set-sync:[mdsw= ModeSwitching ][,src= SynchronizationSource ]
[aisthres= AISThreshold ][,auto= SyncAutoreconfiguration ];
later)andR7.0OC-12for(BBF4
thepack,circuitTG3BBF4orTGSBBF2BtheusingWhen
SynchronizationSource forlineopticaltheselecttousedisparameter shelf
timing.
TIMINGEXTERNAL-SYSTEMSRING
set-sync:[mdsw= ModeSwitching type)pack(BBF2];
set-sync:[mdsw= ModeSwitching ][,src= SynchronizationSource ];
type)pack(BBF2B
set-sync:[mdsw= ModeSwitching ][,src= SynchronizationSource ]
[,aisthres= AISThreshold ];
later)andR7.0OC-12for(BBF4
NOTE:
provisionedhardwareispackcircuitTG3orTGStheifapplications,allFor
themode,OUTSYNCinoutputDS1for SynchronizationSource
output.DS1forlineopticaltheselecttousedalsoisparameter
are:parametersinputThe
mdsw values:followingtheofonehavemayModeSwitching
revertive value).(defaultswitchingmodeRevertive
toduemodetimingholdovertoswitchessystemtheIf
automaticallywillitreferences,timingtheoffailurea
modetimingprovisionedthetobackswitch
(External or LineTimed theofoneafter)
good.becomesreferences
nonrevertive switching.modeNonrevertive
toduemodetimingholdovertoswitchessystemtheIf
willitreferences,timingtheoffailurea not
timingprovisionedthetobackswitchautomatically
(mode External or LineTimed referencetheafter)
Thegood.becomes switch-sync mustcommand
provisionedthetosystemtherestoretousedbe
(modetiming External or LineTimed).
11-310 1997December1Issue OC-12DDM-2000

Lucent Technologies DDM-2000 OC-12 Specifications

General

Brand	Lucent Technologies
Model	DDM-2000 OC-12
Category	Multiplexer
Language	English