21
4) Press and release inch/mm to move the cursor to the position above the digital
character to be changed. Continuous use of inch/mm will cause the cursor to
move one space at a time to the right and then begin again at the leftmost posi-
tion (Figure 6).
Figure 6 - Moving the Cursor Position
5) To select and change the digital value, position the cursor above the digit loca-
tion to be changed. Press the ZERO/ON to select the digital value. Press and
release the ZERO/ON key to advance to the available digits of 0 through 9 (Fig-
ure ).
NOTE: Continuous use of this key will cause the digits to repeat.
Figure 7 - Entering Preset Value
To Next Page
Loading...
Need help?
General
