Manitou MLT 961-145 V PLUS L JD ST4 S1 User Manual

3 - 28
Ü
1000 HOUR - PERIODIC MAINTENANCE - EVERY 1000 HOURS OF SERVICE OR 2 YEARS
IN ADDITION, CARRY OUT PERIODIC MAINTENANCE FOR 500 HOURS OF SERVICE.
CHECK Seat belt
t
IMPORTANT
t
The lift truck must not be used if the seat belt is defective (fixing, lock, seams, tears, etc.).
Repair or replace the seat belt immediately.
SAFETY BELT WITH TWO FIXING POINTS
- Check the following points:
• The fixing of the anchoring points on the seat.
• The cleanliness of the belt and the locking mechanism.
• The clicking of the locking mechanism.
• The state of the belt (tears, fraying).
REELED SEAT BELT WITH TWO ANCHORING POINTS
- Check the afore-mentioned points and those below:
• Correct sliding of the belt.
• The state of the winder plates.
• The locking of the winder mechanism by pulling the belt with one firm pull.
NOTE: After an accident, replace the seat belt.
REGENERATE "Parked telehandler" exhaust particulate filter
t
IMPORTANT
t
Exhaust particle filter cleaning is an automated procedure activated by the operator when the help screens are
displayed
i
!
i
!
AUTO
OFF
.
Once the exhaust particle filter regeneration procedure is completed, leave the I.C. engine idling for a few minutes to
lower the temperature before switching off the ignition.
- Park the telehandler in a safe and adequately ventilated place.
- Check the following points:
• Forward/reverse selector in neutral,
• Parking brake applied,
• Boom angle less than 5°,
• I.C. engine temperature greater than 60 °C.
- Check that there is sufficient fuel.
- Start the telehandler and run the I.C. engine for a few minutes to bring it up to its operating temperature.
- Press down on the top of switch 1 for more than two seconds to begin the regeneration procedure.
- The help screen
i
P
will be displayed, the indicator light will come on, then a beep will sound to confirm that
“stationary telehandler” particle filter regeneration is running. Failing this, the help screen
i
will appear and a
beep will sound. Recheck the positioning of the telehandler and contact your dealer if necessary.
t
IMPORTANT
t
The exhaust particle filter regeneration procedure must only be stopped in case of necessity.
If the operator presses the forward or reverse selector during regeneration, the procedure will automatically be halted.
To properly interrupt the procedure, press the bottom of switch 1.
During the procedure, the I.C. engine speed is controlled by the engine electronic control unit.
- The time taken for exhaust particle filter regeneration to complete varies (between 20 and 50 minutes) according to
various criteria, such as:
• The level of clogging of the filter,
• The ambient temperature,
• The fuel quality and type of I.C. engine oil,
• The number of exhaust particle filter automatic regeneration requests previously cancelled.
- The help screen
i
P
and the light will come on when the regeneration procedure has finished. The engine
speed returns to idle.
1
649100 EN-US-AU (20/05/2019) MLT 961-145 V PLUS L JD ST4 S1

Manitou MLT 961-145 V PLUS L JD ST4 S1 Specifications

General

Brand	Manitou
Model	MLT 961-145 V PLUS L JD ST4 S1
Category	Front End Loaders
Language	English