EasyManuals Logo

Manitou MLT 961-145 V PLUS L JD ST4 S1 User Manual

Manitou MLT 961-145 V PLUS L JD ST4 S1
180 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #137 background imageLoading...
Page #137 background image
3 - 29
CLEAN Fuel tank
Place the telehandler on level ground with the I.C. engine stopped.
t
IMPORTANT
t
Do not smoke or use a naked flame during this operation.
Never try to perform welding or other operations on your own, taking into account the risk of explosion or fire.
- Check by sight and by touch parts where possible leaks of the fuel circuit and tank
may occur.
- In case of leaks, contact your dealer.
- Place a container under drain plug 1 and unscrew the plug.
- Open the fuel filler access panel with the ignition key.
- Remove filler plug 2 to facilitate draining.
- Rinse out with ten liters of clean diesel through filler port 3.
- Fit the drain plug back on and tighten it (tightening torque: 72 to 88 Nm).
- Fill the tank with clean filtered diesel through the filler hole.
- Refit the filling cap.
2
3
1

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Manitou MLT 961-145 V PLUS L JD ST4 S1 and is the answer not in the manual?

Manitou MLT 961-145 V PLUS L JD ST4 S1 Specifications

General IconGeneral
BrandManitou
ModelMLT 961-145 V PLUS L JD ST4 S1
CategoryFront End Loaders
LanguageEnglish

Related product manuals