2 - 28
MAJOR FAULT WARNING LIGHT
When this light is on it indicates that there is a major fault that may affect the safety for the telehandler or the driver. Stop the
telehandler and refer to the error codes (e: 2 – DESCRIPTION: 6D - DISPLAY: MENU SCREEN).
GREEN LIGHT FOR LOW BEAM
BLUE LIGHT FOR MAIN BEAM
AIR FILTER CLOGGING LIGHT
The light comes on when the air filter cartridge is clogged up. When this light remains continuously lit the cartridge needs
changing. Stop the telehandler and carry out the necessary repairs (e: 3 - MAINTENANCE: MAINTENANCE TABLE).
HYDRAULIC RETURN OIL FILTER CARTRIDGE CLOGGING LIGHT
The light comes on when the hydraulic return oil filter cartridge is clogged up. When this light remains continuously lit the
cartridge needs changing. Stop the telehandler and carry out the necessary repairs (e: 3 - MAINTENANCE: MAINTENANCE
TABLE).
NOTE: This light comes on by cold weather or when starting the fork telehandler, it goes off when the hydraulic oil reaches
its operating temperature.
POWER-ASSISTED STEERING FAULT INDICATOR LIGHT
If the light comes on when the telehandler is running, stop the I.C. engine immediately and look for the cause (possible leak, etc.).
BRAKE FLUID LEVEL OR BRAKING FAULT INDICATOR LIGHT
If the light comes on, when the telehandler is running, stop the I.C. engine immediately and search for the cause:
- check proper brake oil level, pressure of the braking circuit or any leaks
- servobrake fault
- front axle brake fault
- rear axle brake fault
- brake accumulator fault
- brake booster fault
- trailer brake fault (only for Italy)
If the level is unusually low or there are other faults, contact your dealer.
HIGH EXHAUST GAS TEMPERATURE INDICATOR LIGHT
The light comes on while the telehandler is running to indicate a high exhaust gas temperature.
WATER IN FUEL PRE-FILTER LIGHT
This light will come on when there is water in the fuel pre-filter. Stop the telehandler and carry out the necessary repairs (e:
3 - MAINTENANCE: MAINTENANCE TABLE).
I.C. ENGINE AUTOMATIC PREHEATING LIGHT
This light comes on and should go out as soon as pre-heating is ended. If it comes on while the telehandler is in operation,
immediately stop the I.C engine and find the cause.
I.C. ENGINE OIL PRESSURE INDICATOR LAMP
If the light comes on when the telehandler is running, stop the I.C. engine immediately and look for the cause (see oil level
in I.C. engine crankcase).
649100 EN-US-AU (20/05/2019)
MLT 961-145 V PLUS L JD ST4 S1
To Next Page
Loading...
Need help?
General
