Manitowoc MLC300 User Manual

Manitowoc Published 11-20-19, Control # 234-19 4-105
MLC300 OPERATOR MANUAL SETUP AND INSTALLATION
3
1
4
Install Boom Top Camera and Connect
Electric Cables
See Figure 4-72 for the following procedure. Refer to the
decal on the side of the boom top for a detailed wiring
diagram.
1. Remove the camera (1, View C) from storage in the job
box.
2. Slide the camera shaft (2, View C) into the bracket (3)
and install the hair-pin cotter (4).
3. Attach the security chain from the camera to the eyebolt
(6, View C).
4. Connect the electric cable (5, View C) to the bracket (7,
View D) in the boom top (8).
5. Pay out electric cable (9, View B) from the cable reel
(10) and connect the electric cable (9, View D) to the
bracket in the boom top (8).
6. Secure the cable to the cable clips on the bottom left
chord of the boom sections
7. Connect the electric cable (11, View B) from the rotating
bed to the other end of the electric cable (9) at the cable
reel (10).
8. Connect the electric cables from the boom butt to the
suggested receptacles in the camera switchers (12,
View A). See the following wiring diagram.
Figure 4-72 continued
Item Description
1 Upper Monitor in Cab
2 Upper Camera Switcher (on rotating bed)
3 VPC-MAX Rear Camera (on fixed mast)
4 Drum 5 Camera
5 Drum 6 Camera
6 Drum 1 Camera
7 Lower Monitor in Cab
8 Lower Camera Switcher (on rotating bed)
9 Drum 2/3 Camera
10 VPC-MAX Rear Camera (on rotating bed)
11 Drum 4 Camera
12 Cable Reel in Boom Butt
13 Boom Top Camera
14 Cable Reel in Luffing Jib Butt
13 Luffing Jib Top Camera

Manitowoc MLC300 Specifications

General

Brand	Manitowoc
Model	MLC300
Category	Construction Equipment
Language	English