SETUP AND INSTALLATION MLC300 OPERATOR MANUAL
4-168
Published 11-20-19, Control # 234-19
RIGGING WINCH OPERATION
If your crane is equipped with the optional rigging winch
(Drum 0), see the Rigging Winch Assembly drawing at the
end of this section for wire rope routing and anchoring.
See Figure 4-113
for the following procedures.
Selecting Rigging Winch Mode
TO TURN RIGGING WINCH ON —
1. Scroll to the rigging winch selection screen (4) in the
Main Display. See MLC300 Main Display Operation
Manual for instructions.
2. Use either the jog dial on the right console or the scroll
keys on the Main Display to highlight the ON (I) icon (5)
in the selection box.
3. Press the select button on the jog dial or on the Main
Display to select the highlighted mode. The screen
changes to reflect the change.
TO TURN RIGGING WINCH OFF —
1. Scroll to the rigging winch selection screen (4) in the
Main Display. See MLC300 Main Display Operation
Manual for instructions.
Figure 4-113
Item Description
1 Rigging Winch in Boom Butt
2 Wire Rope Guide (2)
3 Lever
A Free-Spool
BPower
4 Rigging Winch Selection Screen
5 Rigging Winch ON
6 Rigging Winch OFF
To Next Page
Loading...
Need help?
General
