Manitowoc MLC300 User Manual

Manitowoc Published 11-20-19, Control # 234-19 4-133
MLC300 OPERATOR MANUAL SETUP AND INSTALLATION
3
1
4
Store Carbody Side Platforms
Reverse the installation steps to store the carbody side
platforms (see Deploy Carbody Side Platforms on
page 4-55).
Remove Carbody Front and Rear Platforms
Reverse the installation steps to store the carbody front and
rear platforms (see Install Carbody Front and Rear Platforms
on page 4-53).
Secure the platforms to a trailer for shipping.
Prepare Crawlers for Removal
1. Disconnect the hydraulic hoses and the electric cable
from between the carbody and each crawler. See Views
C and D, Figure 4-36 on page 4-48
.
2. Thoroughly clean:
• Hydraulic hose ends
• Hydraulic couplers
• Electric cable connectors
• Dust caps
3. Install dust caps on the carbody hydraulic couplers (7
places each crawler).
4. Install dust caps on the carbody electric receptacles (2
places).
See Figure 4-89
for the remaining steps.
5. At each crawler on past production units, install a dust
cap on the end of the electric cable (3, View A1) and
attach the cable to the crawler with a plastic wire tie.
6. At each crawler on current production units, connect the
electric cable (3, View A2) to the storage receptacle (4).
7. At each crawler, connect the hydraulic hoses (2, Views
A1 or A2 and B) to the storage couplers (1).
Deploy Carbody Jacks
Reverse the storage steps (see Store Carbody Jacks on
page 4-53) to deploy the carbody jacks.

Manitowoc MLC300 Specifications

General

Brand	Manitowoc
Model	MLC300
Category	Construction Equipment
Language	English