EasyManuals Logo

Manitowoc National Crane NBT30H-2 Service Manual

Manitowoc National Crane NBT30H-2
194 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #141 background imageLoading...
Page #141 background image
7
National Crane 03-20-2019 Control # 613-06 7-9
NBT30H-2 SERVICE MANUAL OUTRIGGERS
NOTE: To prevent damage to the OMS string
potentiometer, do not allow the cable (3) to retract
freely.
4. Disconnect the electrical cable (6) connector and secure
to avoid damage.
5. Completely remove the mounting hardware (4) for the
string potentiometer.
6. Remove the OMS string potentiometer (5) from the
outrigger cover plate.
Installation
1. Install the string potentiometer (5) on the inside of the
outrigger cover plate (1).
2. Connect the electrical cable (6) to the OMS string
potentiometer.
3. Attach the OMS string potentiometer connector (2) to
the attaching point on the outrigger beam.
NOTE: To prevent damage to the OMS string
potentiometer, do not allow the cable to retract
freely.
4. Install the outrigger cover plate to the outrigger box and
secure with the hardware.
5. Calibrate string potentiometer; refer to Calibration, page
7-9
Calibration
Calibrating the string potentiometer is done through the
crane's RCL. Refer to RCL Sensor Calibration, page 3-19.

Table of Contents

Other manuals for Manitowoc National Crane NBT30H-2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Manitowoc National Crane NBT30H-2 and is the answer not in the manual?

Manitowoc National Crane NBT30H-2 Specifications

General IconGeneral
BrandManitowoc
ModelNational Crane NBT30H-2
CategoryConstruction Equipment
LanguageEnglish

Related product manuals