EasyManuals Logo

Manitowoc National Crane NBT30H-2 Service Manual

Manitowoc National Crane NBT30H-2
194 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
National Crane 03-20-2019 Control # 613-06 1-29
NBT30H-2 SERVICE MANUAL INTRODUCTION
1
10
Method 1
Using a length of soft annealed wire, place one end in the
groove between two strands of the wire rope. Turn the long
end of the annealed wire at right angles to the wire and wrap
it tightly over the portion in the groove.
The two ends of the annealed wire should be twisted
together tightly. Cut off the excess wire and pound the twist
flat against the wire rope (Figure 1-11).
Method 2
Wind a length of soft annealed wire around the wire rope at
least seven times. Twist the two ends together in the center
of the seizing. Tighten the seizing by alternately prying and
twisting. Cut off both ends of the wire and pound the twist flat
against the rope (Figure 1-12).
NOTE: Non-preformed wire rope should have two seizings
located on each side of the cut (Figure 1-13).
FIGURE 1-11
FIGURE 1-12
FIGURE 1-13
PREFORMED
NON-PREFORMED
Before Cutting
After Cutting
Before Cutting
After Cutting
6 Rope
Diameters

Table of Contents

Other manuals for Manitowoc National Crane NBT30H-2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Manitowoc National Crane NBT30H-2 and is the answer not in the manual?

Manitowoc National Crane NBT30H-2 Specifications

General IconGeneral
BrandManitowoc
ModelNational Crane NBT30H-2
CategoryConstruction Equipment
LanguageEnglish

Related product manuals