Maple Systems Silver Series - Page 57

2. From the Edit menu, click Align, then Top or click the appropriate icon from the Manager
toolbar.
3. From the Edit menu, click Undo to put the objects back in their original position.
4Using the align bottom command
1. Select the objects you wish to align. For this example, select the three rectangle objects of
Window_12
2. From the Edit menu, click Align, then Bottom or click the appropriate icon from the
Manager toolbar.
3. From the Edit menu, click Undo to put the objects back in their original position.
4Using the align horizontal center command
1. Select the objects you wish to align. For this example, select the three rectangle objects of
Window_12
1010-1001a, Rev 02
Using EZware-500 53