Service manual
10 of 46MAC Encore Performance - Revision A, 12-20-2017
Repair and maintenance
Base
Removing the base covers
1. Disconnect the xture from power and let it
cool for 15 minutes until the PSU have been
discharged.
2. Remove the two screws (1) on the front and back
cover.
3. Pull off the base covers (2) sideways.
Figure 8: Removing the screws
Figure 9: Pulling of the base covers
Figure 10: Removing the voltage insulation cover
4. To remove the voltage insulation covers (3),
loosen the four Torx10 screws (4) on each side of
the base and pull up the cover.
5. Follow the procedure in reverse order.
1
2
4
4
3
To Next Page
Loading...
