Service manual
43 of 46MAC Encore Performance - Revision A, 12-20-2017
Figure 95: Legend, maintenance schedule
Lubricating of the guide rails for the
zoom/focus module and the CMY
module
Use Klüber Barrierta high-temperature lubricant (P/N
37302015) on axels, iris gears and other surfarces that
require lubrication.
Always reapply lubricant if it is required according to
the maintenance schedule or if you install new parts.
Always use the correct amount of lubricant. Do not
over-lubricate.
Before you reaplly lubricant, make sure to wipe clean
the axles, rails and joints with a paper towel.
If you apply lubricant to an axel:
1. Apply a small amount of lubricant to the shafts of
the sliding component.
2. To test if the amount of lubricant applied is
sufcient, move the sliding components back and
forth to distribute the grease.
NOTE! The sliding components should only leave
a very thin deposit of lubricant on the shaft.
Conditions
Procedures in the cells marked with red must be
carried out by certied Martin
®
by Harman technicians
only. Otherwise, you may cause damage to the product
that is not covered by your product warranty.
Ambient temperature:
Minimum: 5° C (41° F).
Maximum: +40° C (104° F).
Daily “lamp-on” hours: 8 hours.
Voltage and frequency: 120-240 V nominal, 50/60 Hz.
I Inspect
R Replace
C Clean
L Lubricate
A Adjust
U Update
Martin
®
by Harman
To Next Page
Loading...
