Martin MAC Encore Performance - Animation Wheel Replacement Procedure; General Information; Safety Instructions

Service manual
4 of 46MAC Encore Performance - Revision A, 12-20-2017
Figure 1: Safety instructions
Figure 2: Tools
Figure 3: ESD mat and wristband
General information
This service manual contains information about how to
service MAC Encore Performance.
Safety instructions
Before you carry out service work, read this document.
Installation and service work must comply with local
regulations and accepted codes of good practice.
Observe the safety instructions in the user manual for
the product.
Tools
Make sure that the tools below are available before you
start working on the product:
• ESD mat and wristband.
• Locktite.
• Gloves.
• Torx10 screwdriver.
• Torx20 screwdriver.
• Torx25 screwdriver.
• Umbraco key, 3 mm.
• Alle set key.
• Small atheaded screwdriver.
• Marker and tape.
Important! Take the necessary
precautions to prevent static
electricity from damaging the
product during modication or
repair.