Martin MAC Encore Performance - Rear End; Removing the Rear End Covers

Service manual
31 of 46MAC Encore Performance - Revision A, 12-20-2017
Figure 71: Position of the spring
7. Replace the framing blade
NOTE! Make sure that the spring (5) stays in
place.
8. Follow the procedure in revese order.
5
Figure 73: Removing rear end cover
5. Remove the two Torx20 screws (3) on each side.
6. Remove the two rear end covers (4).
7. Follow the procedure in reverse order.
3
4
Figure 72: Removing rear end plastic cover
Rear end
Removing the rear end covers
1. Remove the head covers. See “Removing the
head covers” on page 20.
2. Remove the front side covers. See “Removing the
front side covers” on page 20.
3. Remove the four Torx20 screws (1).
4. Remove the rear end plactic cover (2).
1
1
2