Martin MAC Encore Performance - Replacing the Animation Wheel

Service manual
29 of 46MAC Encore Performance - Revision A, 12-20-2017
Figure 66: Placing the framing module
Replacing the animation wheel
1. Remove the head covers. See “Removing the
head covers” on page 20.
2. Remove the front side covers. See “Removing the
front side covers” on page 20.
3. Remove the multimodule. See “Replacing the
multimodule” on page 26.
4. Loosen the ve Torx20 screws (1).
1
7. Replace the animation wheel (5).
NOTE! Make sure that the indexing marks (6) are
aligned.
8. Follow the procedure reverse order.
5
6
6
Figure 65: LooseningveTorx20screws
Figure 67: Aligning the indexing marks
5. Place the framing module (2) next to the gobo and
effect module (3).
6. Gently loosen the magnetic holder (4) with a small
atheaded screwdriver.
2
3
4
5