Service manual
15 of 46MAC Encore Performance - Revision A, 12-20-2017
Figure 25: How not to fasten yoke covers
5. Follow the procedure in reverse order.
NOTE! Make sure that no wires are stuck
between the yoke covers.
Figure 24: How not to fasten yoke covers
Figure 23: Removing the yoke covers
Yoke
Removing the yoke covers
1. Disconnect the xture from power and let it
cool for 15 minutes until the PCBAs have been
discharged.
2. Remove the three Torx25 screws (1) on both
sides of the yoke cover.
3. Remove the four Torx20 screws on both handles.
4. Remove the yoke covers.
1
2
2
To Next Page
Loading...
