Service manual
40 of 46MAC Encore Performance - Revision A, 12-20-2017
Adressing driver PCBA CAN bus ID
It is only necessry to assign CAN bus ID if you have
replaced a driver PCBA and the missing modules error
(MMER) is displayed.
The driver PCBA’s ID is assigned in the modules menu
which you nd in the Advanced Service menu.
1. Scroll down to the service menu.
2. Hold the center button until the progress bar on
the display is full.
3. When you are asked if you are a Martin® certied
technician, click YES by pressing the UP button.
4. Then press the center button to conrm.
5. Scroll down until you nd the module menu and
select ENTER.
6. You will see an overview of the driver boards in
the xture and their function.
Driver board Function
Effect For effects and framing on the effect
part of the multimodule.
CMY For CMY and framing on the CMY
part of the multimodule.
Zoom/Focus For zoom/focus/frost located on one
side of the zoom/focus tunnel.
Pan/Tilt Mainboard with display in the base.
7. Next to the driverboard, you can see the text
FOUND, MISSING or REDUNDANT.
Text Action
FOUND -
MISSING Assign the correct ID.
REDUNDANT The same ID is assigned to two
driver boards. Change the ID.
NOTE! the pan and tilt driver PCBA does not have an
ID. Normally, the ID is set automatically when the zoom
focus and effect driver IDs are set correctly.
8. Select the function that is MISSING and press
enter.
9. A number will appear that you can change. This is
the CAN bus ID for the driver PCBA.
10. When you change the ID, a red LED will start to
ash on the driver PCBA when you have selected
the correct ID.
11. Press SELECT to the save the ID.
12. Click YES.
13. The xture will reset and the error message
MMER disappears.
To Next Page
Loading...
