Service manual
20 of 46MAC Encore Performance - Revision A, 12-20-2017
Figure 39: Removing the head covers
Replacing the tilt motor
1. Remove the yoke covers. See “Removing the
yoke covers” on page 15.
2. Loosen the tilt and pan belts.
3. Remove the screws (1).
4. Remove the PCBA (2).
5. Follow the procedure in reverse order.
1
1
2
Figure 38: Replacing the tilt motor
Removing the front side covers
1. Disconnect the xture from power and let it
cool for 15 minutes until the PSUs have been
discharged.
2. Remove the two Torx25 screws (1).
3. Remove the front side covers.
4. Follow the procedure in reverse order.
1
Figure 40: Removing the front side covers
Head
Zoom-focus module
Removing the head covers
1. Disconnect the xture from power and let it
cool for 15 minutes until the PSUs have been
discharged.
2. Remove the two Torx25 screws (1).
3. Remove the safety wire (1).
4. To fasten the head, follow the procedure in
reverse order.
1
2
To Next Page
Loading...
