Service manual
16 of 46MAC Encore Performance - Revision A, 12-20-2017
Figure 26: Cutting the cable ties
4. Pull out the connectors.
Figure 28: Removing the ground wire
A
B
C
D
5. Remove the ground wire (2).
6. Move the cables to the center.
2
Figure 27: Pulling out the connectors
Replacing the pan belt
1. Remove the yoke covers. See “Removing the
yoke covers” on page 15.
2. NOTE! If you loosen or change position of the pan
belt and/or motors, you must calibrate the xture.
See “Calibrating the pan, tilt and zoom function”
on page 20
3. Cut the eleven cable ties (1).
1
1
To Next Page
Loading...
