Service manual
27 of 46MAC Encore Performance - Revision A, 12-20-2017
Separating the multimodule
You can separate the multimodule into three modules:
• Framing module (1)
• Gobo and effect module (2)
• CMYC module (3).
Figure 60: CMYC module pointing upwards
3
2
1
Figure 59: Separating the multimodule
5. Disconnect the motors and switches (1).
6. Remove the six screws (2).
7. Open the module so that the cyan and magenta
color lters are on one side and the yellow and
CTC color lters are on the other side.
1
2
Separating the CMYC module from the multimodule
NOTE! Only use genuine Martin
®
color lters. Handle
and store the lters with care. Always wear cotton
gloves while handling the color lters. Always keep the
color lters perfectly clean.
1. Remove the head covers. See “Removing the
head covers” on page 20.
2. Remove the front side covers. See “Removing the
front side covers” on page 20.
3. Remove the multimodule. See “Replacing the
multimodule” on page 26.
4. Place the multimodule on a clean surface with the
CMYC module pointing upwards.
Figure 61: Removing six screws
To Next Page
Loading...
