Martin MAC Encore Performance - Replacing the DC-DC PCBA; Replacing the Fan Assembly; Replacing The Air Filter

Service manual
14 of 46MAC Encore Performance - Revision A, 12-20-2017
Figure 21: Replacing the fan assembly
Replacing the fan assembly
1. Remove the base covers. See “Removing the
base covers” on page 10.
2. Gently pull away the fan assembly (1) from the
xture.
3. Replace the fan assembly.
4. Follow the procedure in reverse order.
Figure 22: Replacingtheairlter
Replacingtheairlter
1. Remove the base covers. See “Removing the
base covers” on page 10.
2. Pull away the lter assembly (1) from the xture.
3. Gently pull off the lter retainer to access the air
lter.
4. Replace the air lter.
5. Follow the procedure in reverse order.
1
1
Figure 20: Replacing the DC-DC PCBA
Replacing the DC-DC PCBA
1. Remove the base covers. See “Removing the
base covers” on page 10.
2. Remove the yoke covers. See “Removing the
yoke covers” on page 15.
3. Remove the fan assembly. See “Replacing the fan
assembly” on page 14.
4. Remove the four Torx25 screws (1).
5. Disconnect the connectors.
6. Replace the DC-DC PCBA.
7. Follow the procedure in reverse order.
1
1