Service manual
37 of 46MAC Encore Performance - Revision A, 12-20-2017
Figure 89: Removing the LED engine
Replacing the LED engine
1. Follow the procedure in “Replacing the reector”
on page 36.
2. Gently remove the LED engine with your ngers.
3. Follow the procedure in reverse order.
Figure 91: Removing four connectors
Replacing the driver board
1. Follow step 1-8 in the procedure in “Replacing the
lens” on page 32.
2. Disconnect the four connectors (1).
1
Figure 90: Replacing the LED engine
4. Replace the LED engine.
NOTE! In the light engine and light engine
assembly, make sure that the position screws (1)
are turned in a way that they t in the slot.
Before you fully tighten the screws make sure that
the LED engine is aligned according to the marks
you made in “Replacing the lens” on page 36.
5. Follow the procedure in reverse order.
1
1
To Next Page
Loading...
