Service manual
26 of 46MAC Encore Performance - Revision A, 12-20-2017
Multimodule
Replacing the multimodule
1. Remove the head covers. See “Removing the
head covers” on page 20.
2. Remove the front side covers. See “Removing the
front side covers” on page 20.
3. Place the xture with the front lens pointing
downwards the base.
4. Lock the tilt function (1) in this position.
NOTE! The focus lens will slide out of the
multimodule and down towards the front lens
which make it possible to remove the multimodule.
Figure 56: Locking the tilt function
1
Figure 58: Replacing the multimodule
7. Replace the multimodule (4).
8. Follow the procedure in reverse order.
4
5. Loosen the four screws (2) that hold the
multimodule.
6. Disconnect the CAN BUS and the DC power to
the distribution board (3).
Figure 57: Disconnecting CAN BUS and DC power
2
2
2
3
To Next Page
Loading...
