Service manual
24 of 46MAC Encore Performance - Revision A, 12-20-2017
Figure 50: Removing the focus assembly
14. Gently lift it up sideways to free the belt from the
lower pulley.
15. Remove the complete focus assembly (9).
9
Figure 52: Removing the frost spring
Replacing the frost lter arm
1. Remove the head covers. See “Removing the
head covers” on page 20.
2. Remove the front side covers. See “Removing the
front side covers” on page 20.
3. Remove the multimodule. See “Replacing the
multimodule” on page 26.
4. Remove the zoom lens assembly. See “Removing
the front side covers” on page 20
5. Remove the frost spring (1).
1
Figure 51: Removing the focus assembly
16. Remove the four screws (10) that hold the focus
belt retainer on the focus lens.
17. Take off the focus belt (11) with the retainer.
18. To remove the focus belt from the retainer (13),
remove the two screws (12) that hold the clamp.
19. Follow the procedure in reverse order.
10
10
13
12
12
11
To Next Page
Loading...
