Service manual
23 of 46MAC Encore Performance - Revision A, 12-20-2017
Figure 47: Loosening the belt tensioner
6. Losen the two screws (1).
7. Loosen the belt tensioner (2) as much as
possible.
8. Tighten one of the screws (1) again.
NOTE! It will ease the removal and installation of
the belt.
1
2
Figure 49: Releasing the cable guide
11. Very gently release one end of the cable guide (5)
with a atheaded screwdriver.
12. Pull the cable and connector (6) through the hole.
13. Pull off the focus belt (7) from the top pulley (8).
5
6
7
8
Figure 48: Pulling out connectors
9. Cut the cable tie (3).
10. Pull out connector H5 (4) on the PCBA.
3
4
To Next Page
Loading...
