Martin MAC Encore Performance - Replacing the Framing Blade

Service manual
30 of 46MAC Encore Performance - Revision A, 12-20-2017
Figure 68: LooseningveTorx20screws
Replacing the framing blade
1. Remove the head covers. See “Removing the
head covers” on page 20.
2. Remove the front side covers. See “Removing the
front side covers” on page 20.
3. Remove the multimodule. See “Replacing the
multimodule” on page 26.
4. Loosen the ve Torx20 screws (1).
1
Figure 69: Placing the framing module
6. Remove the two Torx10 screws (4).
4
Figure 70: Removing the Torx10 screws
5. Place the framing module (2) next to the gobo and
effect module (3).
2
3