Service manual
25 of 46MAC Encore Performance - Revision A, 12-20-2017
Figure 53: Replacing the focus lens assembly
6. Loosen the Allen set screw (2) that holds the frost
belt onto the motor.
2
Figure 55: Position of zoom/focus sensors
Position of the zoom/focus sensors
The sensors are magnetic sensors with LEDs. The
LED is green if the sensor is powered and the LED is
orange if the sensor is activated by a magnet.
3
Figure 54: Setting the correct distance
7. Use a 3 mm Umbraco key (3) as spacer to set the
correct distance.
8. Follow the procedure in reverse order.
3
To Next Page
Loading...
